Drum Tuner guides
How to tune a snare drum
A snare sounds right when every lug on a head gives the same pitch and the two heads sit a set distance apart. Here is the whole job in order.
Before you start
- Turn the snare wires off so they do not buzz while you listen.
- Put the drum on a towel or a pillow so the head underneath is muffled. You want to hear one head at a time.
- Have a drum key and a quiet few minutes.
1. Seat the top head
Loosen every rod until it turns freely. Tighten each one with your fingers until it just touches the hoop. Press the middle of the head with your palm a few times to settle it. A few small cracking sounds from the glue are normal on a new head.
2. Bring it up evenly
Work across the drum, not around it: tighten one rod, then the one opposite, then move on. Give each rod the same amount, a half turn at a time at first, then quarter turns. Stop when the wrinkles are gone and the head gives a clear note when tapped.
3. Match the lugs
Tap the head about an inch in from each rod and listen to the pitch. Find the lugs that sound lower than the rest and bring them up a little. If one sounds higher than the rest, back it off and come up to pitch again. Go around until every lug gives the same note. This step matters more than the exact pitch you land on.
4. Set the pitch of the top head
Once the head is even, raise or lower all the rods by the same small amount to move the whole head. A lower top head feels soft and sounds fat. A higher one feels firm, sounds crisp and gives more bounce.
5. Tune the snare-side head higher
Flip the drum and repeat steps 1 to 3 on the thin bottom head. Tune it higher than the top head, usually by a fourth to a fifth (five to seven semitones). The thin head needs that tension to make the wires respond. Be gentle: it is the thinnest head on the kit.
6. Check by ear
Put the drum on its stand, turn the wires on and play it. If it rings too long, tune the top head down a little or add a small piece of damping. If the wires sound choked, loosen the strainer before you touch the heads.
Starting pitches by snare size
These are the starting ranges Drum Tuner uses for the pitch of the whole drum. Low in the range is fatter, high is crisper. Treat them as a place to begin, not a rule.
| Head size | Drum pitch, low to high | Nearest notes |
|---|---|---|
| 10" | 260 to 380 Hz | C4 to F#4 |
| 12" | 230 to 330 Hz | A#3 to E4 |
| 13" | 210 to 300 Hz | G#3 to D4 |
| 14" | 180 to 270 Hz | F#3 to C#4 |
Let your phone find the low lugs
Drum Tuner listens while you tap near each lug and tells you which rod to turn and which way, until the head is even and at the pitch you picked. Your first complete drum is free, both heads included.
Download on the App StoreMore: how to tune toms · how to tune a kick drum · pitch chart by drum size